薄抹灰轻质聚合物抗裂砂浆耐候性试验研究.pdf
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 抹灰 聚合物 砂浆 耐候性 试验 研究
- 资源描述:
-
2014年第3期(总第293期)
泥
预拌砂浆
Number 3 in 2014( Total No293
Concrete
READY MIXED MORTAR
doi:10.3969jiss.1002-3550.2014.03.034
簿抹灰轻质聚合物抗裂砂浆耐候性试验研究
苏志杰,路永华a,关淑君2,马捷2,宋跃军a
(1.北京工业大学a.建筑工程学院;b.城市与T程安全减灾教育部重点实验室,北京100124
2.中国建筑科学研究院,北京100013)
摘要;按照《嘭胀聚苯板薄抹灰外墙外保温系统》标准,对外墙外保温用轻质专用抹面砂浆1、轻质专用抹面砂浆I及常用聚
合物抹砂浆进行标准养护、耐侠性试验(热箱环80次、热冷循5次)片的力学性能对比,同时,对3种砂浆利用SEM进行
微观机理研究。结果表明:3种砂浆经历·定次数的热雨循环和热冷循环后,其抗压、抗折强度有不同程度的降低,压折比有不同
程度的增大;微观研究与宏观上3种砂浆的抗压、抗折强度表现相一致。轻质专用抹面砂浆I和轻质专用抹面砂浆I抗裂性优于
常用聚合物砂浆。
关键词:外墙外保温;枺面砂泶;耐候性试验;微观研究
中图分类号:TU528.041文献标志码:A文章编号:1002-3550(2014)03-0124-03
Research on lightweight polymer mortar under weather test
SU Zhijie, I U Yonghua a GUAN Shujun 2, MA Jie, SONG Yuejun a
(a College of Architecture and Civil Engineering; b,. The Key Laboratory of Urban Security and Disaster Engineering
Ministry of Education, Beijing Univcrsity of Technology, Beijing 100124, China
2. China Academy of Building Research, Beijing 100013, China;
Abstract: According to" enal thermal insulation composit systems ased on exanded polystyrene It was studied on the mechanical
properties of polymer plaster mortars which are i t polymer m r I, i weight polymer mortar I[ and commonly used polyme
notar for extemal thermal insulation composite systems ( ETICS under weathering test and Standard curing. At the same time, it was
tudie n the mi ue si M ao ese three mor ar The results demonstrated that the compressive strength and the flexurai
strength of these three polymer plaster mortars for ETIS all declined o different extent, the flexural and compresi strength ratio of
polymer plaster mortars increased. The study of Microstructure is consistent with the compressive strength and the flexural strength
Lightweight olymer mor ar I and lightweight pol mortar are er than commonly used polymer mor ar
Key words: external thermal insulatio composite systems plaster mortars weathering test microstructural research
0言
性试验条件下相关力学性能进行研究,并对聚合物砂浆进
行扫描电镜试验,从微观上分析不同砂浆内部结构、,为提
建筑外增采用外保温技术,存在着多方面的优越性,
高外墙外保温系统的抗裂性提供理论支持。
其中最主要的是其有效避免了冷桥的存在。随着我国建筑
节能要求与舒适性要求的不断提高,外墙外保温技术迅速
试验研究
扩火。但是,由于外墙保温系统常年经灵季节変化、饱受风
试验材料
雨的侵袭,致使外保温面层开裂,严重影响了下程质量和正
常使用。致使外啬倸温面层的裂缝是保温建筑质量通病中
(1)本试验中轻质专用砂浆I和轻质专用砂浆Ⅱ均由乳
的重症。内此,防裂是墙体保温体系要解决的关键技术之一。
胶料(含一定比例的水)和粉料组成,乳胶和粉料按质量比
目前,由于市场常用聚合物抹面砂浆主要由水泥砂浆
14配合比混合,再加人15~2.0份水搅匀后,静置5~10min
掺加聚合物和外加剂等构成,与保温材料之问的匹配性较使用
差,在温度作用下抹画砂浆层经 ANSYS有限元分析是应
常用聚合物砂浆兑水25%~309%使用
力、应变集中部位,会因为抹面砂浆层柔朝性变形能力不
本试验所用砂浆各成分及用量(不含水)表
足出现开裂现象。压折比在一定程度上能够反映出砂浆的1.2试验条件
柔韧性好坏、因此,对外墙外保温用聚合物抹面砂浆耐候
耐候性试验按JG149-2003《肜胀聚苯板薄抹灰外墙
收稿日期:2013-09-29
金项目:件建部项目
124
展开阅读全文
文档分享网所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



链接地址:https://www.wdfxw.net/doc81542056.htm