ASMT B 905关于漆膜附着力的测定方法.pdf

Designation: B 905-00
Standard Test Methods for
Assessing the Adhesion of Metallic and Inorganic Coatings
by the Mechanized Tape Test
This standard is issued under the fixed designation 13 905; the number immediately following the designation indicates the year ol
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year o! last reapproval
superscript epsilon (E)indicates an editorial change since the last revision or reapprov
1. Scope
B 281 Practice for Preparation of Copper and Copper-base
Alloys for Electropla
d Co
Coati
the adhesion of metallic and inorganic coatings and other thin
B 319 Guide for Preparation of Lead and Lead Alloys for
films to metallic and nonmetallic substrates. Assessment is
made by applying pressure-sensitive tape to a coated surface
B 320 Practice for Preparation of Iron Castings for Electro
and then utilizing a mechanical device to remove the tape at a
plating
regulated, uniform rate and constant angle while simulta-
B 343 Practic
Preparation of Preparation of Nickel fo
recording the removal force
Electroplating with Nickel
1.2 Four methods are described. Methods A1 and A2 are
B 480 Guide for Preparation of Magnesium and Magnesium
Alloys for Electroplating
intended primarily for use in labora ory evaluations Methods B 481 Practice for Preparation of Titanium and T
itanium
BI and B2 are not recommended for testing coatings and films
ectroplatlng
on polymer substrates
B 482 Practice for Preparation of Tungsten and Tungsten
1. 3 These test methods may be used to establish whether the
Alloys for Electroplating"
adhesion of a coating to a substrate is within a required range B 537 Practice for Rating of Electroplated Panels Subjected
(between a quantified low and a quantified high level). Deter
to Atmospheric Exposure'
mination of actual adhesive forces requires more sophisticated B>38 Method of FACT(Ford Anodized Aluminum Corro
methods of measurement. In multilayer systems adhesion
sion) Tests
failure may occur between intermediate coating layers so that
B 558 Practice for Preparation of Nickel Alloys for Electro-
coating system to the substrate ma
pP
not necessarily be determined
B 629 Practice for Preparation of Molybdenum and Molyb-
1.4 This standard does not purport to address all of the
denum Alloys for Electroplating
safely concerns, if any, associated with iis use. II is the
B 630 Practice for Preparation of Chromium for Electro-
responsibility of the user of this standard to establish appro
plating with Chromium
priate safety and health practices and determine the applica
B 727 Practice for Preparation of Plastics Materials for
bility of regulatory limilations prior to use
Electroplating
D 1730 Practices for Preparation of Aluminum and
Referenced Documents
Aluminum-alloy Surfaces for Painting
2.1 AST Standards
D 1731 Practices for Preparation of Hot-dip Aluminum
B 183 Practice for Preparation of Low-carbon Steel for
Surfaces for Painting
Electroplating
D 1732 Practices for Preparation of Magnesium Alloy Sur
B 242 Practice for Preparation of High-carbon Steel for
faces for Painting
Electroplating"
D 2370 Test