NF EN 10228-1无损探伤.pdf

INTRANORMES pour: ALSTOM TRANSPORT
FEO37802
ISSN0335-3931
European standard
NFEN10228-1
June 1999
French standard
Classification index: A 04-315-1
ICS:77.040.20
Non-destructive testing of steel forgings
Part 1 Magnetic particle inspection
F: Essais non destructifs des pieces forgees-partie 1: Controle
par magnetoscope
D Zerstorungsfreie Prufung von Schmiedestucken aus Stahl
ell 1: Magnetpulverprufung
French standard approved
by decision of the Director General of AFNOR on May 5, 1999 taking effect on
June5.1999
て
Replaces the approved standard NF A 04-309 dated June 1990
C
Correspondence The European standard EN 10228-1: 1999 has the status of French standard
Analysis
This document defines the procedures regarding magnetic control and the
acceptance criteria of ferromagnetic material forgings
Descriptors
Technical International Thesaurus: forgings, ferromagnetic materials
nondestructive tests, magnetic particle testing, surface condition, defects, inspection
setting-up conditions, acceptability, quality classes
Modifications
With respect to document replaced, resumption of the European standard
Corrections
Published and distributed by Association Francaise de Normalisation(Afnor-french standard institute)- 11, avenue Francis de Presense-
93571Saint-denisLaPlaineCedex-tel.:+33(0)141628000-fax:+33(0)149179000-www.afnor
O AFNOR 1999
AFNOR 1999
1st issue 1999-06-P
INTRANORMES pour: ALSTOM TRANSPORT
NFEN10228-1:1999
National foreword
References to French standards
The correspondence between the standards figuring in the clause ormative references" and the identical French
standards is as follows
EN473
NF EN 473(classification index. A 09-010)
pre/ ISO 9934-1 F E /SO 9934-1(classification index. A 09-590-1
PREN /SO 9934-2 F EN ISO 9934-2(classification index: A 09-590-2) 1)
PREN /SO 9934-3 NF EN ISO 9934-3(classification inde: A 09-590-3
1) Currently being prepared
INTRANORMES pour: ALSTOM TRANSPORT
EUROPEAN STANDARD
EN10228-1
NORME EUROPEENNE
EUROPAISCHE NORM
March 1999
English version
Non-destructive testing
of steel forgings-part 1 Magnetic
particle Inspection
Essais non destructifs des pieces forgees-partie 1
Zerstorungsfreie Prufung von Schmiedestucken aus Stahl
Controle par magnetoscope
Teil 1 Magnetpulverprufung
This European Standard was approved by CEN on 1 March 1999
CEN members are bound to comply with the CEN/CENELEC nternal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member
This European Standard exists in three official versions(English, French, German).A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions
CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece
Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal,