EN 13244-2003 通用排水地下和地上压力系统的塑料管道系统.聚乙烯(PE).pdf

BRITISH STANDARD
BS EN
13244-2:2002
3 Plastics piping systems
O
ffor buried and
NoNoO+H≤OO0寸=o
above-ground pressure
systems for water for
general purposes,
drainage and
sewerage
O
00
Polyethylene (PE
05-600
Part 2 Pipes
0oE60-605
The European Standard EN 13211-2: 2002 has the status Of a
British Standard
⊥CS23.040.20;93.030
0050
古
NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW
British Standards
IBS EN13244-2:2002
0aoo=s
National foreword
This Brilish Standard is Whe official English language version of
EN13244-2:2002. collectively,EN13244-1,EN13244-2 and EN13244-5
supersede
BS 6437: 1984, Spec i/calion for polyethylene pipes(lype 50)in meric
for general pure
which wil be declared obsolescent by December 2004
NOTE 1 The UK waler industry has indicated thal Tollowing the publicalion of this Brilish
Standard, the [ollowing Water Industry Specifieation will be declared obsolescent by March 2005
and retained for refcrence where applicable
NoNoo+=zoo
WIS 1-32-17(Issue 2), Specif lion for polyethylene pressure pipes or pressurised ucaler
supply and sewerage cuties)
The UK participation in its prcparation was entrusted bytechnical Committce
PRI88(prcviously PRI/61), Plastics piping systems, to Subcommittee PRI/88/2
(previously PRI/61/2) Plastics piping systems for pressure applications, which
has the responsibility to
aid enquirers to understand the text
O寸∞寸-
resent to the responsible internationa /uropean committee ar
cnquirics on the interpretation, or proposals for change, and kcep the
UK interests informed
monitor related international and European developments and
promulgate them in the UK
O
A list of organiza Lions represented on this subcommittee can be obtained on
00
request, Lo ils secretary
NOTE 2 Tt was decided not to procced with the publication of PREN 13244-6, Recommended
absence of a British Standard covering installation, It is the opinion of Technical Committee the
practice for instalation and that existing national practices would be applicable. In the UK, in the
oEo0-0
PRI/88, Plastics piping systems, that reference to the Polyethylene Pipe Systems Mamwa12), a joint
ablicalion of WRE and Bpr Plastic Pipes Group represenls eslablished UK praclice
NOTE 1 Part 7 has been prepared as a CENTS, to allow Turther development. CEN/TS 13211-7
is not mandatory under the Public Procurement Direclive
Attention is drawn to the following statutory regulations
Iicalth and Safcty at Work cte Act 1974 and subsequent regulations
Altcntion is also drawn to any appropriate safcty precautions. IL is assumed in
ne drafting of a standard that the execution of its provisions is entrusted to
appropriately qualified peop
1)Published by WRC, Swindon
2) WRC/PT PTAASTTC PIPES GROUP. Polyethylene ipe Systems Manul
Swindon: WRC. 2002
O This British Standard, was
o published under the authority Amendments issued since publication
of Lhe Standards Policy and
Strategy Commitlee on
お11 December2003
Amd No
Date
Comments
C BSI II December 200
c①
ISBN0580430278