低合金钢热膨胀系数测定和分析.pdf
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 低合金钢 热膨胀 系数 测定 分析
- 资源描述:
-
第21卷第3期
材料科学与
艺
Val 21 Na. 3
2013年6月
MATERIALS SCIENCE TECHNOLOGY
Jun.,2013
低合金钢热膨胀系数测定和分析
操龙飞2,徐光,邓鹏2,吴隽2,吴润2
1.武汉科技大学材料与冶金学院,武汉430081;
2.武汉科技大学锅铁冶金及资源利用省郁共建教育部重点实验室,武汉430081)
摘要:按照国标对某热连轧生产线上的两种典型钢种的热膨臘系数进行实验测量,得出其线性热膨率、
平均线膨胀系数和瞬线膨系媺温度的变化曲线,对比分析了钢种的化学成分对总膨胀量的影响夹质
以及取样方向对膨胀系数的影响,结果表明:金属材料的化学成分主要通过影响相变点盪而影响影量;
取样方向不影响金属材料的膨胩系数,即膨胩系数是各向同性的.实验得到两个钢种在不属温度段的熱膨胀
系数值,为实际的宽度在线控制提供了依据
关犍词:低合金钢;热膨胀系数;瞬时线膨胀系数;相交点;取样方向
中图分类号:TG113.22;TG11.5
文献标志码:A文章编号:1005-029(2013)03-0105-05
Measurement and analysis of thermal expansion coefficients of low alloy steel
CAO Long-feil2, XU Guang", DENG Peng", WU Jun", WU Run
(1. Faculty of Materials and Metallurgy, Wuhan University of Science and Technology, Wuhan 430081, China
2. Key Laboratory for Ferrous Metallurgy and Resoures Utiliation of Ministry of ducation, Wuhan University
of Science and Technology, Wuhan 430081, China)
Abstract: The thermal expansion coefficients of two typical steel grades on hot continuous rolling product ine
were measured by standard experiments, and the curves of linear, average and instant expansion coefficients
versus the temperature were given. The effect of chemical composition on total thermal expansion and the
influence of sampling dircetion on expansion coefficients were investigated. The results show that the elect of
chemical composition on coefficient of thermal expansion is caused by the change of phase trans ormation
points. The coeficient of thermal expansion(CTE )is not affected by sampling direction, which means that
the CTE is isotropic. The CTES in different temperature periods provide the basic foundation for the on-line
control of width of these steels
Key words low alloy steel coeffieient of thermal expansion; instant linear expansion coefficient; phase trans-
formation points; sampling direction
热镀锌板具有耐腐蚀、可美化产品外观、有利道,并且已有的相关热影胀数据不能很好地应用
于后续加工、减少环境污染等优点而广泛应用于丁实际生产中,本文选取上述两种有代表性的热
汽车等行业.低合金结构钢中加入少量的合金连轧产品进行热膨胀系数的测定和分析,为其宽
元素,极大地提高其使用性能,如高强度、耐度的在线控制提供理论依据,并对热膨胀系数的
磨、耐腐蚀、时高温等,在[业生产中也有厂泛应一些基本规律进行探讨?
用.目前对这两个钢种热膨胀参数的研究少兄报
热膨胀是物体因温度改变而出现的胀缩现
象,固体的热膨胀是固体中相邻原子间的平均距
收稿日期:2012-05-17
基金項目:溯北省教育厅重点项目(D2012110
离随温度的升高而增大,由原子的非简谐振动引
作者简介:操龙飞(1987-),男,硬土研究生;
起的.目前,关于金属材料热膨胀方的研究报道
徐光
)、男,教授,博土生异师
非常少, Ruffal给出了材料热膨胀系数与原子间
通信作者:徐光,E-mail: xuguang@wust.elu.c
距及其他热力学参数之间的关系, Megaw给出
万方数据
展开阅读全文
文档分享网所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



链接地址:https://www.wdfxw.net/doc69037510.htm