JIS L0849-1996 耐摩擦色牢度测试方法.pdf

UDC677.016:535.685
JS
JAPANESE INDUSTRIAL STANDARD
Test method for
colour fastness to rubbing
JISL0849-9%6
Translated and Published
y
Japanese Standards Association
Printed in Japan
4 S
In the event of any doubt arising,
the original Standard in Japanese is to be final authority
Errata for JIS(English edition)are printed in Standardization Journal, published monthly
by the Tapanese Standards Association
rata will be provided upon request, please contact
Business Department
Japanese Standards Association
4-1-24. Akasaka, Minato-ku
Tokyo, JAPAN 107
TEL,03-3583-8002
FAX.03-3583-0462
Errata are alsc provided to subscribers of JIS(English edition )in Monthly Information
TheStandardisdownloadedfromStandardSharing
UDC677.016:535.68
JAPANESE INDUSTRIAL STANDARD
J IS
Test method for colour fastness to rubbing
L0849-1996
1. Scope This Japanese Industrial Standard specifies a method for determining
the resistance of the colour of the dyed textiles to rubbing
Remarks 1. The following standards are cited in this Standard:
JIS L 0801
General principles of test methods for colour fastness
JIS L 0803 Standard adjacent fabrics for staining of colour
fastness test
JIS L 0805 Grey scale for assessing staining
JIS R 6253 Waterproof abrasive papers
2. The following is the International Standard corresponding to this
Standard
S0 105-X12: 1993 Textiles-tests for colour fastness-part X12:
Colour fastness to rubbi
ng
Principle
In this test, the specimen is rubbed with an undyed cotton cloth
for rubbing in a specified way using rubbing tester. The staining of the undyed cotton
cloth
is assessed
compared with the grey scale for assessing staining and the colour fastness
lassification Test shall be cla
wet rubbing test
ifed into two kinds of dry rubbing test and
Apparatus and materials Th
he following apparatus and materials shall be used
(1) Rubbing tes
(1.1)Rubbing tester type I(crock meter) This tester consists of specimen stage,
waterproof abrasive paper, rubbing finger, loading arm, horizontal reciprocation
device, etc. as shown in Fig. I, and shall conform to the following specification
a)Specimen stage Metallic or wooden stage finished by coating or the like
so as not to be affected even at the time of wet test
(b)Waterproof abrasive paper C, GC-P320 specified in JIS R 6253 or the one
equivalent thereto and of the size measuring approximately 140 mm x 110 mm
(C)Rubbing finger
Of 16+1 mm in diameter: with flat end surface; made of
rigid plastic, wood, or chemicalproof material and capable of fitting tightly
the undyed cotton cloth measuring approximately 50 mm X 50 mm
oading arm
Constructed so as to be capable of applying a load of 9N
to the rubbing finger at one end and to make the rubbing finger possible
to reciprocate horizontally on the specimen
e)Horizontal reciprocation device(rubbing finger
So constructed that the
rubbing finger of the loading arm can reciprocate horizontally ten times for
ten seconds along a 100 mm track on the specimen by a crank or the like