合金的显微组织与力学性能.pdf
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 合金 显微 组织 力学性能
- 资源描述:
-
18卷第4期
中国有色金属学扌报
VOL18 No 4
The Chinese ournal of Nonferrous Vctals
Apr.2008
文章编号:1004-0609(2(008)04-0571-06
AI-Cu-Mg-(Ag,La)合金的显微组织与力学性能
肖代红,黄伯云,宋旼,陈康华
中南大学粉木治金国家重点实验室,长沙410083
摘要:采用金相显微镜、打描电镜、透射电镜与力学性能測试等方法,研究Ag与La对Al5.3Cu-0.8Mg(质量
分数,%)合念的显微组织与时效特性的影响。结果表明:添加0.Lla降低铸态A1-5.3Cu-0.8Mg-(0.6g)合念的晶
粒尺寸:但并不能明显提高挤压态A1-5.3Cu-0.8Mg合金的时效硬化:添加0.6Ag能提高挤压态Al-5.3Cu0.8Mg
合金的时效埂化能力与抗拉强度,降低185℃时的峰时效时间。这是由于Ag的添加改变基体合的时效析出相,
合金的主要强化相由片状Ω相和少量の相组成。同时,添加0.6Ag与0.ILa有助于提高Al-5.3Cu-0.8Mg合金中Ω
相的体积分数,最终使其力学性能得到进一步改善。
关键词:铝合金:Ag:La:显微组织:力学性能
中图分类号:TG146.21
文献标识码:A
Microstructures and mechanical properties of Al-cu-mg-(Ag, La)alloys
XIAO Dai-hong, IIUAN(i 1bai-yun, SON(i Min, CIII: N Kang-hua
(State Key Laboratory of Powder Metallurgy, Central South University, Changsha 410083, China)
Abstract: A scrics of Al-5.3CU-0SMY (mass fraction, )based aloys with dinlcrenl Ay and I a contcnts werc
investigated by optical microscope(OM), scannin electron microscopy(EM), transmission electron microscopy(TEM)
and mcchanical propcrtics testing. The results show that adding 0.11a relines the grains of as-cast
Al-5. 3cu-08mg-(0.6ag)alloys, but does not improve the hardness of the extruded Al-5. 3CU-0.M alloys. Addin
0.6g can inerease the hardness and tensile strength of extruded Al-5.3cu-Smg alloys and deerease the peak-aging time
at 185 C. The coherent plate-like S phase and a small ammount of phase are the predominant hardening phases of the
M1-5.3cu-08mg-0 6ag alloys at peak-aged stage al 185 C. Moreover, adding 011.a into Al-5.3cu-08mg-06y alloy
decreases the size and improves the density and the thermal stability of 42 phase, and then improves the mechanical
properties of the alloy
Key words: alumimum alloys: Ag: La: microstructure; mechanical properties
铝铜镁系合金具有中等强度及耐高温性能,已被150~250℃的温度下具有优良的热稳定性,从而改善
广泛用做航空航天结构材料。该合金主要用于不超过了合金的耐热性能,是一种很有希望用于军用和民用
100℃的工作环境,超过此温度时,由于其强化相(の的耐中温结构铝合金。早期对 Al-cu-mg-ag合金的研
相和S相)发生粗化而使力学性能显著下降。在高究主要集中于Ω相的晶体结构,尽管其结构还在
CuMg比例的Al-Cu-Mg合金中加入微量Ag能使合争论之中,但通常认为其是一种正交品系结构的相
金析出一种新的时效强化相(Q相)2,该相在呈片状,在基体的11la面上形核,化学组成近似为
基金项目:中国博士后科学基金资助项目(20070410986):中南大学博士后科学基金资,功项目:粉末治金国家重点实验室开政基金资助项目
收稿日期:2007-09-13:修订日期:2007-12-19
通讯作者:肖代红,副研究员,博士:电话:0731-8836773:E-mail: dailong( Tmail. csu.ecu.cn
展开阅读全文
文档分享网所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。



链接地址:https://www.wdfxw.net/doc28180791.htm