国际电工委员会IEC标准.doc

国际电工委员会IEC标准
IEC 60331-11:着火条件下电缆的测试-电路完整性-第11部分:着火条件下电缆的测试-电路完整性-第11部分:仪器-火焰温度至少750℃条件下的单独燃烧
IEC 60331-11:Tests for electric cables under fire conditions – Circuit integrity – Part 11: Apparatus – Fire alone at a flame temperature of at least 750 Degrees
Abstract摘要
This part of IEC 60331 specifies the test apparatus to be used for testing cables required to maintain circuit integrity when subject to fire alone where the test condition is based upon a flame with a controlled heat output corresponding to a temperature of at least 750 °C.
It also provides in annex A the method of verification of the burner and control system used for the test.
IEC 60331-21:着火条件下电缆的测试 电路完整性 第21部分:程序和要求 额定电压0.6/1.0kV及以下的电缆
IEC 60331-21:Tests for Electric Cables under Fire Conditions - Circuit Integrity - Part 21: Procedures and Requirements - Cables of Rated Voltage up to and Including 0.6/1.0 kV
Abstract摘要
This part of IEC 60331 specifies the test procedure and gives the performance requirement, including a recommended flame application time, for cables of rated voltage up to and including 0,6/1,0 kV required to maintain circuit integrity when subjected to fire under specified conditions.
It describes the means of sample preparation, continuity checking arrangements, electrical testing procedure, method of burning the cables and gives requirements for evaluating test results.
It is intended to cover low voltage power cables, and control cables with a rated voltage.
IEC 60331-23:着火条件下电缆的测试 电路完整性 第23部分:程序和要求 电数据电缆
IEC 60331-23:Tests for Electric Cables under Fire Conditions - Circuit Integrity - Part 23: Procedures and Requirements - Electric Data Cables
Abstract摘要
This part of IEC 60331 specifies the test procedure and gives the performance requirement, including a recommended flame application time, for electric data cables required to maintain circuit integrity when subjected to fire under specified conditions.
It describes the means of sample preparation, continuity checking arrangements, electrical testing procedure, method of burning the cables and gives requirements for evaluating test results.
It covers electric data cables which have no rated voltage and are used for extra low voltage circuits.
IEC 60331-25:着火条件下电缆的测试 电路完整性 第25部分:程序和要求 光缆
IEC 60331-25:Tests for Electric Cables under Fire Conditions - Circuit Integrity - Part 25: Procedures and Requirements - Optical Fibre Cables
Abstract摘要
This part of IEC 60331 specifies the test procedure, and gives the performance requirement, including a recommended flame application time, for optical fibre cables required to maintain circuit integrity when subjected to fire under specified conditions.
It describes the means of sample preparation, continuity checking arrangements, optical testing procedures, the method of burning the cables and gives requirements for evaluating test results.
IEC 60332-1:着火条件下电缆和光缆的测试.第1部分:单根绝缘电线或电缆垂直火焰蔓延的测试
IEC 60332-1:Tests on Electric Cables Under Fire Conditions Part 1: Test on a Single Vertical Insulated Wire or Cable
IEC 60332-2:着火条件下电缆的测试 第2部分:单根小垂直绝缘铜电线或电缆的测试
IEC 60332-2:Tests on Electric Cables Under Fire Conditions Part 2: Test on a Single Small Vertical Insulated Copper Wire or Cable
Abstract摘要
Specifies the procedure for testing the resistance to vertical flame propagation for a single small vertical electrical insulated conducto