EN 14219-2003米制细牙螺纹法兰面螺栓.pdf

三UROP= AN SANDARD
EN14219
NORME EUROPEENNE
EUROPAISCHE NORM
April 2003
ICS21.060.10
English version
Hexagon bolts with flange with metric fine pitch thread
Small series
(ISO 15072: 1999, modified
Vis a tete hexagonal a embase
Sechskantschrauben mit Flansch mit
cylindro-tronconique a pas fin-serie Feingewinde- Leichte Reihe
etroite (SO 15072: 1999, modifiee
(S0 15072: 1999, modifiziert
This European Standard was approved by CEN on 2003-02-14
CEN members are bound to comply with the CEN/CENELEC Internal Regulations
which stipulate the conditions for giving this European Standard the status of a
national standard without any alteration
Up-to-date lists and bibliographical references concerning such national stand
ards may be obtained on application to the Management Centre or to any
CEN member
The European Standards exist in three official versions( English, French, German
A version in any other language made by translation under the responsibility of a
CEN member into its own language and notified to the Management Centre has
he same status as the official versions
CEN members are the national standards bodies of Austria, Belgium, the Czech
Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland
Ireland, Italy, Luxembourg, Malta, the Netherlands, Norway, Portugal, Slovakia
Spain, Sweden, Switzerland, and the United Kingdom
CEN
European Committee for Standardization
Comite Europeen de Normalisation
Europaisches Komitee fur Normung
Management Centre: rue de Stassart 36, B-1050 Brussels
O 2003. CEN -All rights of exploitation in any form and by any means
Ref.No.EN14219:2003E
reserved Worldwide for CEN national members
Page 2
EN14219:2003
Foreword
This document(EN 14219: 2003)has been prepare by Technical ommittee CEN/TC 185 Threaded and non-
threaded mechanical fasteners and accessories, the secretariat of which is held by DIN
This European Standard shall be given the status of a national standard, either by publication of an identical text o
by endorsement, at the latest by October 2003, and conflicting national standards shall be withdrawn at the latest
by October 2003
According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following coun
tries are bound to implement this European Standard: Austria, Belgium, Czech Republic, Denmark, Finland,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal
Slovakia, Spain, Sweden, Switzerland and the United Kingdom
Endorsement notice
The text of the International Standard ISO 15072: 1999 was approved by CEN as a European Standard with agreed
common modifications as given below
Bolts in accordance with this European Standard correspond to those specified in the International Standard
I SO 15072: 1999 with the exception that the width across flats for M12 is 16 mm(instead of 15 mm)and that the
property class 9.8 was deleted. Moreover, the option for surface coatings according to ISO 10683 was added