MIL-PRF-14409 13M-2010 Capacitors Variable (Piston Type Tubular Trimmer) Styles PC26.pdf
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- MIL-PRF-14409 13M-2010 Capacitors Variable Piston Type Tubular Trimmer Styles PC26 MIL PRF 14409 13
- 资源描述:
-
INCH POUND
MIL-PRF-14409/13M
11June2010
SUPERSEDING
MIL-PRF-14409/13
25Juy2001
PERFORMANCE SPECIFICATION SHEET
CAPACITORS, VARIABLE(PISTON TYPI
TUBULAR TRIMMER), STYLES PC26
This specification sheet is approved for use by all Departments
and Agencies of the Department of Defense
The requirements for acquiring the capacitors described herein shall consi
of this specification sheet and MLL-PRF-14409
234-64UNS-2A-
116MA
(SEE NOTE 6) A
(SEE NOTE 5
100
SEE
MIN
NOTE 4
ーー-ーー
020X,080
±.005T0.020
SEE
016 TYP
NOTE 7
±,005
031 TYP
±,008
005
A
SECTION A-A
SEE NOTE 8)
Inches
SEAL CAP
〔 SEE NOTE9
005
0.13
008
0.20
016
0.4
0.51
0.79
2.03
2.54
77
NOES
116
2.95
1. Dimensions are in inches
5.94
2. Metric equivalents are given for general information only
3. Unless otherwise specified, tolerance is*. 016 inch(0. 41 mm
4. If solder is used, the soldering of the turret cap to the cylinder, and of the cylinder to the base and to the base
leads shall be accomplished with a high temperature solder having a melting point of+300 C+50c-5c
For PIN PC26J060, dimension shall be094*.005(2.39 mm+ 0.13 mm)
6. For PIN PC26J060 thread shall be190-64 UNS-2A
7. For PIN PC26J300, two terminals shall be used of same size and length as front terminals
8. For PIN PC26J060, dimension shall be 078*.008(1.95+0.20 mm
9. Seal cap shall be slotted
FIGURE 1. Dimensions and confiqurations
TABLE L. Capacitor characteristics
Part or
Capacitance
ance
Dimensions 1/
Identifying
A
C
D
E
umber
In
Max
土.025
Max
PIN)
ax
(0.64)
PF
PF
0.6
6.010.,000
541
156
250
240
(6.76
(5.59)(13.74)「(3.96
(6.35)
(6.10)
PC26T100
0.8
10.0
5.000
297
578
219
211
7.14)「(14.68)
(7.92)
(5.36)
PC26J100
0.8
10.0
5.000
578
219
3
(7.54)
14)「(14.68)「(5.56)「(7.92)「(5.36)
PC26T1401.014.03,000
578
219
500
218
(7.54)「(7.14)「(14.68)「(5.56)「(12.70)「(5.54)
40
1.014.0
3,0
578
218
7.54)「(7.14)「(14.68)「(5.56)「(12.70)(5.54)
PC26T200
1.020.01,500
562
219
500
196
(14.27)「(7.14)「(20.35)「(5.56)(12.70)「(4.98)
Pc26J2001.0120.011,500.562
28
219
500
(14.27)「(7-14)「(20.35)(5.56)「(12.70)「(4.98)
PC26J300
1.030.0
750
219
500
96
(19
(7.14)(24.61)(5.56)(12.70)(4.98)
1/Metric equivalents are shown in parentheses for information only
REQUIREMENTS
Dimensions and configuration: See figure 1 and table
DC voltage rating: 250 volts
Construction: Alumina ceramic
Dielectric: Air
Capacitance range: See table I
Insulation resistance: Shall not be less than 1,000, 000 megohms at room ambient temperature and not less thar
00, 000 megohms at +125C
Test condition: 250 volts *10 percent
Quality factor (Q): See table I
Test frequency: 100 MHZ +10 MHZ
Driving torque: Greater than or equal to 0.5 ounce-inch and less than or equal to 6.0 ounce-inches from-55c
through +125 C (characteristic展开阅读全文
文档分享网所有资源均是用户自行上传分享,仅供网友学习交流,未经上传用户书面授权,请勿作他用。
关于本文
本文标题:MIL-PRF-14409 13M-2010 Capacitors Variable (Piston Type Tubular Trimmer) Styles PC26.pdf
链接地址:https://www.wdfxw.net/doc96176409.htm
链接地址:https://www.wdfxw.net/doc96176409.htm