MIL-DTL-19803G-2007.pdf

AMSC N/A FSC 1660 MIL-DTL-19803G 05 February 2007 SUPERSEDING MIL-C-19803F 24 March 1982 DETAIL SPECIFICATION CONVERTER, LIQUID OXYGEN, 10-LITER, GCU-24A/A Reactivated after 05 February 2007 and may be used for new and existing designs and acquisitions. This specification is approved for use by all Departments and Agencies of the Department of Defense. 1. SCOPE 1.1 Scope. This specification covers one type of aircraft converter, GCU-24A/A, used for storing and pressuring 10 liters of liquid oxygen. 2. APPLICABLE DOCUMENTS 2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This section does not include documents cited in other sections of this specification or recommended for additional information or as examples. While every effort has been made to ensure the completeness of this list, document users are cautioned that they must meet all specified requirements of documents cited in sections 3 and 4 of this specification, whether or not they are listed. 2.2 Government documents. 2.2.1 Specifications, standards and handbooks. The following specifications, standards, and handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract. Comments, suggestions, or questions on this document should be addressed to: Commander, Naval Air Warfare Center Aircraft Division, Code 491000B120-3, Highway 547, Lakehurst, NJ 08733-5100 or emailed to thomas.omaranavy.mil. Since contact information can change, you may want to verify the currency of this address information using the ASSIST Online database at http:/assist.daps.dla.mil. INCH-POUND Source: http:/ - Downloaded: 2008-02-05T06:25Z Check the source to verify that this is the current version before use. MIL-DTL-19803G 2 FEDERAL STANDARD FED-STD-595 - Colors Used in Government Procurement: Color number: 14187 COMMERCIAL ITEM DESCRIPTIONS A-A-58092 - Tape, Antiseize, Polytetrafluorethylene A-A-59503 - Nitrogen, Technical DEPARTMENT OF DEFENSE SPECIFICATIONS MIL-PRF-9050 - Valves, Oxygen, Pressure Relief, Aircraft MIL-DTL-25516 - Connectors, Electrical, Miniature, Coaxial, Environment Resistant Type, General Specification for MIL-PRF-25567 - Leak Detection Compound, Oxygen Systems MIL-PRF-25961 - Valve, Fill-Buildup-Vent, Liquid Oxygen Converter, CRU-50/A MIL-PRF-27210 - Oxygen, Aviators Breathing, Liquid and Gas DEPARTMENT OF DEFENSE STANDARDS MIL-STD-129 - Military Marking for Shipment and Storage MIL-STD-130 - Identification Marking of U.S. Military Property MIL-STD-461 - Requirements for the Control of Electromagnetic Interference Characteristics of Subsystems and Equipment MIL-STD-810 - Environmental Engineering Considerations and Laboratory Tests MIL-STD-889 - Dissimilar Metals MIL-STD-1916 - DoD Preferred Methods for Acceptance of Product Source: http:/ - Downloaded: 2008-02-05T06:25Z Check the source to verify that this is the current version before use. MIL-DTL-19803G 3 MS22068 - Coupling Assemblies, Quick Disconnect, Aircraft Liquid Oxygen Systems. (Inactive for New Design) MS90341 - Mounting Bracket, Configuration, Mating Portion for 5 and 10 Liter Liquid Oxygen Converters. (Inactive for New Design) DEPARTMENT OF DEFENSE HANDBOOK MIL-HDBK-781 - Reliability Test Methods, Plans, and Environments for Engineering Development, Qualification, and Production (Copies of these documents are available online at http:/assist.daps.dla.mil/quicksearch or http:/assist.daps.dla.mil or from the Standardization Document Order Desk, Building 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.) 2.3 Non-Government publications. The following documents form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract. AMERICAN SOCIETY FOR QUALITY (ASQ) ASQ-Z1.4 - Sampling Procedures and Tables for Inspection for Attributes. (DoD Adopted) (Copies of this document are available from the American Society for Quality, 600 North Plankinton Avenue, Milwaukee, WI 53203-4606 or http:/www.asq.org.) SOCIETY OF AUTOMOTIVE ENGINEERS (SAE) SAE-ARP1176 - Oxygen System and Component Cleaning and Packaging. (DoD Adopted) (Copies of this document are available from www.sae.org or SAE International, 400 Commonwealth Drive, Warrendale, PA 15096-0001.) 2.4 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. Source: http:/ - Downloaded: 2008-02-05T06:25Z Check the source to verify that this is the current version before use. MIL-DTL-19803G 4 3. REQUIREMENTS 3.1 Qualification. The converter furnished under this specification shall be a product that is authorized by the qualifying activity for listing on the a